Drill Doctor

Post by **sharon9999** » Tue Jan 13, 2009 5:22 pm

Yes the Drill Dr. does work,we have one in our shop and get good results with our standard metal cutting bits.You can also sharpen drill bits on a grinding wheel if you have a good eye and know what you're doing.The carbide bits we use are solid carbide,you won't grind off the carbide on the tips of those bits...How ever we usually send out the carbide bits for sharpening.I don't think the Drill Dr. will work out if your bits are carbide.

Post by **Josephine** » Tue Jan 13, 2009 5:26 pm

Andrew wrote:The 10" at the place by the museum are only $8

hmmm - could you be a little bit more specific. such as maybe the name of the "place by the museum" or even which museum you're talking about

i make the drive from lex/dayton about once a month so maybe next time a slight detour into cincy would be in order.

Post by **Andrew** » Tue Jan 13, 2009 5:58 pm

There is a store by Union Termnial off 75. Right by the post office and goldstar dowtown. I forget the name. They have a really good selection of anchors, drills, and tools.

Post by **Andrew** » Tue Jan 13, 2009 6:07 pm

Weldco Buildco Inc
2121 Spring Grove Ave
Cincinnati, OH 45214
513-744-9353

Post by **Josephine** » Tue Jan 13, 2009 6:09 pm

thanks!

Post by **ynot** » Tue Jan 13, 2009 11:06 pm

It's on the opposite corner from Gold Star Chili. They carry Bosch ,bits, blades, all kinds of stuff. My in laws work there. Get off at Freeman, take a right and the next right on Spring Grove, go through the tunnel and it's not far. don't run the stop sign on the other end of the tunnel.

Post by **willmcfarland** » Tue Jan 13, 2009 11:26 pm

Only works on traditional bit, not masonry bits

Post by **the lurkist** » Wed Jan 14, 2009 1:12 am

Hale Machinery on Winchester Road sharpens bits. A handful will cost ten bucks. A few days for turn around.

Post by **ynot** » Wed Jan 14, 2009 1:17 am

Do they sharpen planer and jointer blades? The place they send them to here does lousy work.

Post by **willmcfarland** » Wed Jan 14, 2009 1:31 am

ynot wrote:Do they sharpen planer and jointer blades? The place they send them to here does lousy work.

They may, you can go to Home Depot and look at the box. If you use regular drill bits a lot, especially in wood or soft stuff, they'll sharpen a few times.